Show Poe Pd - NETGEAR ProSafe GSM7224P User Manual

Intf Power Power
(W)
------ ------- -----
1/0/33 No 18.0

show poe pd

Use this command to get information about the PD ports. You can display information based on
each individual port or all the PD ports collectively.
Note: Only the GSM5212P supports this command.
Format
show poe pd [<port> | all]
Mode Privileged EXEC
User EXEC
Term
Intf
Mode
Class
Detection Mode
Status
Example:
(switch) #show poe pd all
Intf Mode
---- -----
0/1 PD
0/2 PD
ProSafe Managed Switch
Class Power Current
(W) (mA)
------- ------ -------
2 04.400 84
Definition
Show the PD device interface number, only 0/1 or 0/2 on the GSM5212P.
In other devices, the table is empty. If <port-id> is not specified, all PD
ports are displayed.
Displays the port POE role and is always PD.
Displays the POE class.
PD detection mode when getting power from the PSE:
• 1-event—PSE detects the PD in 1-event mode (802.1f)
• 2-event—PSE detects the PD in 2-event mode (802.1at)
• LLDP—PSE detects the PD in LLDP mode (802.1at)
Shows whether the port 0/1 or 0/2 is providing power:
• Powered—Receiving power from PSE
• Off—No power from the PSE (when main AC is in used)
Class Detection Mode
--------- ----------------
class 4 2-event
class 4 LLDP
Power over Ethernet (PoE) Commands
Voltage Status
(volt)
------- ------------------
53.3 Delivering Power
Status
----------
500
Fault
Status
---------------
No Error
powered
powered