Spanning-Tree Edgeport; Spanning-Tree Forceversion - NETGEAR ProSafe GSM7224P User Manual

spanning-tree edgeport

This command specifies that this port is an Edge Port within the common and internal
spanning tree. This allows this port to transition to Forwarding State without delay.
Default
enabled
Format
spanning-tree edgeport
Mode
Interface Config
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
no spanning-tree edgeport
Mode
Interface Config

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value.
Default
802.1s
Format
spanning-tree forceversion <802.1d | 802.1s | 802.1w>
Mode
Global Config
• Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE
802.1d functionality supported).
• Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s functionality
supported).
• Use 802.1w to specify that the switch transmits RST BPDUs rather than MST BPDUs
(IEEE 802.1w functionality supported).
no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value.
Format
no spanning-tree forceversion
Mode
Global Config
ProSafe Managed Switch
Switching Commands
49