Transport Output Telnet - NETGEAR ProSafe GSM7224P User Manual

Default
enabled
Format
transport input telnet
Mode
Line Config
no transport input telnet
Use this command to prevent new Telnet sessions from being established.
Format
no transport input telnet
Mode
Line Config

transport output telnet

Use this command to regulate new outbound Telnet connections. If enabled, new outbound
Telnet sessions can be established until the system reaches the maximum number of
simultaneous outbound Telnet sessions allowed. An established session remains active until
the session is ended or an abnormal network error ends it.
Default
enabled
Format
transport output telnet
Mode
Line Config
no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format
no transport output telnet
Mode
Line Config
session-limit
Use this command to specify the maximum number of simultaneous outbound Telnet
sessions. A value of 0 indicates that no outbound Telnet session can be established.
Default
5
Format
session-limit <0-5>
Mode
Line Config
ProSafe Managed Switch
Management Commands
598