Show Ip Verify Source; Show Ip Source Binding - NETGEAR ProSafe GSM7224P User Manual

show ip verify source

Use this command to display the IPSG configurations on all ports.
Format
show ip verify source
Mode
• Privileged EXEC
• User EXEC
Term Definition
Interface
Interface address in unit/slot/port format.
Filter Type
Is one of two values:
• ip-mac: User has configured MAC address filtering on this interface.
• ip: Only IP address filtering on this interface.
IP Address
IP address of the interface
MAC Address
If MAC address filtering is not configured on the interface, the MAC Address field is
empty. If port security is disabled on the interface, then the MAC Address field displays
"permit-all."
VLAN
The VLAN for the binding rule.
Example: The following shows example CLI display output for the command.
(switch) #show ip verify source
Interface Filter Type
--------- -----------
0/1 ip-mac
0/1 ip-mac

show ip source binding

This command displays the IPSG bindings.
Format
show ip source binding [{static/dynamic}] [interface unit/slot/port]
[vlan id]
Mode
• Privileged EXEC
• User EXEC
Term Definition
MAC Address
The MAC address for the entry that is added.
IP Address
The IP address of the entry that is added.
Type
Entry type; statically configured from CLI or dynamically learned from DHCP Snooping.
ProSafe Managed Switch
IP Address MAC Address
--------------- -----------------
210.1.1.3 00:02:B3:06:60:80
210.1.1.4 00:0F:FE:00:13:04
Switching Commands
153
Vlan
-----
10
10