Distribute-List Out (Ospf); Exit-Overflow-Interval (Ospf); External-Lsdb-Limit (Ospf) - NETGEAR ProSafe GSM7224P User Manual

distribute-list out (OSPF)

Use this command to specify the access list to filter routes received from the source protocol.
Format
distribute-list <1-199> out {rip | static | connected}
Mode
Router OSPF Config
no distribute-list out
Use this command to specify the access list to filter routes received from the source protocol.
Format
no distribute-list <1-199> out {rip | static | connected}
Mode
Router OSPF Config

exit-overflow-interval (OSPF)

This command configures the exit overflow interval for OSPF. It describes the number of
seconds after entering overflow state that a router will wait before attempting to leave the
overflow state. This allows the router to again originate non-default AS-external-LSAs. When
set to 0, the router will not leave overflow state until restarted. The range for seconds is 0 to
2147483647 seconds.
Default
0
Format
exit-overflow-interval <seconds>
Mode
Router OSPF Config
no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
Format
no exit-overflow-interval
Mode
Router OSPF Config

external-lsdb-limit (OSPF)

This command configures the external LSDB limit for OSPF. If the value is -1, then there is no
limit. When the number of non-default AS-external-LSAs in a router's link-state database
reaches the external LSDB limit, the router enters overflow state. The router never holds
more than the external LSDB limit non-default AS-external-LSAs in it database. The external
LSDB limit MUST be set identically in all routers attached to the OSPF backbone and/or any
regular OSPF area. The range for limit is -1 to 2147483647.
Default
-1
Format
external-lsdb-limit <limit>
Mode
Router OSPF Config
ProSafe Managed Switch
Routing Commands
281