NETGEAR ProSafe GSM7224P User Manual page 130

• MODULO-N (where N is the number of active link members in a LAG) operation based on
the number of ports in the LAG
• Packet attributes selection based on the packet type: For L2 packets, source and
destination MAC address are used for hash computation. For L3 packets, source IP,
destination IP address, TCP/UDP ports are used.
• Non-Unicast traffic and unicast traffic is hashed using a common hash algorithm
• Excellent load balancing performance.
Default
3
Format
port-channel load-balance
{<unit/slot/port> |<all>}
Mode
Interface Config
Global Config
Term Definition
1
Source MAC, VLAN, EtherType, and incoming port associated with the packet
2
Destination MAC, VLAN, EtherType, and incoming port associated with the packet
3
Source/Destination MAC, VLAN, EtherType, and incoming port associated with the
packet
4
Source IP and Source TCP/UDP fields of the packet
5
Destination IP and Destination TCP/UDP Port fields of the packet
6
Source/Destination IP and source/destination TCP/UDP Port fields of the packet
7
Enhanced Hashing Mode
<unit/slot/port>| all
Global Config Mode only: The interface is a logical unit/slot/port number of a
configured port-channel. "All" applies the command to all currently configured
port-channels.
no port-channel load-balance
This command reverts to the default load balancing configuration.
Format
no port-channel load-balance {<unit/slot/port> | <all>}
Mode
Interface Config
Global Config
Term Definition
<unit/slot/port>| all
Global Config Mode only: The interface is a logical unit/slot/port number of a
configured port-channel. "All" applies the command to all currently configured
port-channels.
ProSafe Managed Switch
{ 1 | 2 | 3 | 4 | 5 | 6 | 7}
Switching Commands
130