Ip Rip Authentication; Ip Rip Receive Version; Distribute-List Out (Rip) - NETGEAR ProSafe GSM7224P User Manual

distribute-list out (RIP)

This command is used to specify the access list to filter routes received from the source
protocol.
Default
0
Format
distribute-list <1-199> out {ospf | static | connected}
Mode
Router RIP Config
no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format
no distribute-list <1-199> out {ospf | static | connected}
Mode
Router RIP Config

ip rip authentication

This command sets the RIP Version 2 Authentication Type and Key for the specified
interface. The value of <type> is either none, simple, or encrypt. The value for
authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of
<type> is encrypt, a keyid in the range of 0 and 255 must be specified. Unauthenticated
interfaces do not need an authentication key or authentication key ID.
Default
none
Format
ip rip authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode
Interface Config
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
Format
no ip rip authentication
Mode
Interface Config

ip rip receive version

This command configures the interface to allow RIP control packets of the specified
version(s) to be received.
ProSafe Managed Switch
Routing Commands
311