Clock Summer-Time Recurring; Sntp Server; Clock Timezone - NETGEAR ProSafe GSM7224P User Manual

sntp server

This command configures an SNTP server (a maximum of three). The optional priority can be
a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format
sntp server <ipaddress|ipv6address| hostname> [<priority> [<version>
[<portid>]]]
Mode
Global Config
no sntp server
This command deletes an server from the configured SNTP servers.
Format
no sntp server remove <ipaddress|ipv6address| hostname>
Mode
Global Config

clock timezone

When using SNTP/NTP time servers to update the switch's clock, the time data received
from the server is based on Coordinated Universal Time (UTC) which is the same as
Greenwich Mean Time (GMT). This may not be the time zone in which the switch is located.
Use the clock timezone command to configure a time zone specifying the number of hours
and optionally the number of minutes difference from UTC. To set the switch clock to UTC,
use the no form of the command.
Format
clock timezone zone-name +/-hours-offset [+/-minutes-offset]
Mode
Global Config
Default
no clock timezone
Zone name: A name to associate with the time zone
Hours-offset: Number of hours difference with UTC
Minutes-offset: Number of minutes difference with UTC
no clock timezone
This command sets the switch to UTC time.
Format
no clock timezone
Mode
Global Config

clock summer-time recurring

Use the clock summer-time recurring command to set the summertime offset to UTC
recursively every year. If the optional parameters are not specified, they are read as either '0'
or '\0', as appropriate.
ProSafe Managed Switch
Utility Commands
539