Show Arp Access-List - NETGEAR ProSafe GSM7224P User Manual

command displays the values for that interface whether the interface is enabled for DAI or
not.
Format
show ip arp inspection interfaces [unit/slot/port]
Mode
• Privileged EXEC
• User EXEC
Term Definition
Interface
The interface ID for each displayed row.
Trust State
Whether the interface is trusted or untrusted for DAI.
Rate Limit
The configured rate limit value in packets per second.
Burst Interval
The configured burst interval value in seconds.
Example: The following shows example CLI display output for the command.
(Switch) #show ip arp inspection interfaces
Interface Trust State
--------------- -----------
0/1
0/2

show arp access-list

Use this command to display the configured ARP ACLs with the rules. Giving an ARP ACL
name as the argument will display only the rules in that ARP ACL.
Format
show arp access-list [acl-name]
Mode
• Privileged EXEC
• User EXEC
Example: The following shows example CLI display output for the command.
(Switch) #show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08
ProSafe Managed Switch
Rate Limit
(pps)
----------
Untrusted
Untrusted
Switching Commands
Burst Interval
(seconds)
---------------
15 1
10 10
160