Pmm Parameters Command; Figure 243 Adsl Downstream Carrier1 Command Display Example - ZyXEL Communications IES-1248-51 User Manual

The following example displays the results.

Figure 243 ADSL Downstream Carrier1 Command Display Example

ras> adsl dscarrier1 5
port
---- |--------|--------|--------|--------|--------|--------|--------|-----
---|
5 00000000 000F0000 00000000 00000000 00000000 00000000 00000000
00000000
Tone:
m0:256-287, m1:288-319, m2:320-351, m3:352-383
m4:384-415, m5:416-447, m6:448-479, m7:480-511

55.1.16 PMM Parameters Command

Syntax:
ras> adsl pmm param <portlist> [<l0time> <l2time> <l2atpr> <l2atprt>]
[<max_l2rate> <min_l2rate> <l0tol2_rate>]
where
<portlist>
<l0time>
<l2time>
<l2atpr>
<l2atprt>
Chapter 55 ADSL Commands
m0 m1 m2
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Set the minimum time in seconds (10~65535) that the ADSL
=
line must stay in L0 power mode before changing to the L2
power mode.
Set minimum time in seconds (10~65535) that the ADSL line
=
must stay in the L2 power mode before reducing the power
again in the L2 power mode.
Set the maximum Aggregate Transmit Power Reduction
=
(ATPR) in decibels (dB) that is permitted in a L2 power
reduction. The system can gradually decrease the ADSL line
transmission power while it is in the L2 power mode. This is the
largest individual power reduction allowed in the L2 power
mode. The range is 0~15(dB).
Set the maximum Aggregate Transmit Power Reduction Total
=
(ATPRT) in decibels (dB) that is permitted in the L2 power
mode. This is the total transmit power decrease that is allowed
to occur in the L2 power mode. The range is 0~15(dB).
IES-1248-51/51A/53 User's Guide
ds carrier
m3 m4 m5 m6 m7
375