Uploading The Default Configuration File; Figure 306 Resetting The Switch Via Command - ZyXEL Communications IES-1248-51 User Manual

2 Enter your password.
3 Type
config restore
4 Type
y
5 The IES-1248 restarts.

Figure 306 Resetting the Switch Via Command

ras> config restore
System will reboot automatically after restoring default configuration.
Do you want to proceed(y/n)? >
restoring configuration...
saving configuration to flash...
The IES-1248 is now reinitialized with a default configuration file including the default user
name of "admin" and the default password of "1234".

58.16.2 Uploading the Default Configuration File

If you forget your password or cannot access the IES-1248, you will need to reload the
factory-default configuration file. Uploading the factory-default configuration file replaces the
current configuration file with the factory-default configuration file. This means that you will
lose all previous configurations and the speed of the console port will be reset to the default of
9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will
also be reset to "1234" and the IP address to 192.168.1.1.
Note: Uploading the factory default configuration file erases the IES-1248's entire
configuration.
Obtain the default configuration file, unzip it and save it in a folder. Use a console cable to
connect a computer with terminal emulation software to the IES-1248's console port. Turn the
IES-1248 off and then on to begin a session. When you turn on the IES-1248 again you will
see the initial screen. When you see the message
within 3 seconds
To upload the configuration file, do the following:
1 Type
atlc
2 Wait for the
on your terminal.
3 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer,
then Send File to display the following screen.
Chapter 58 Troubleshooting
.
at the question "Do you want to restore default ROM file(y/n)?"
press any key to enter debug mode.
after the
Enter Debug
Starting XMODEM upload
IES-1248-51/51A/53 User's Guide
Press any key to enter Debug Mode
Mode message.
message before activating XMODEM upload
439