Mac Count Commands; Mac Count Show Command; Figure 177 Mac Filter Delete Command Example; Figure 178 Mac Count Show Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
<mac>
This command removes a configured source MAC address from the ADSL port that you
specify.
The following example removes the source MAC address of 00:a0:c5:12:34:56 from the MAC
filter for ADSL port 5.

Figure 177 MAC Filter Delete Command Example

ras> switch mac filter delete 5 00:a0:c5:12:34:56

49.3 MAC Count Commands

Use MAC count commands to limit how many MAC addresses may be dynamically learned.
MAC count commands are listed next. When the MAC filter accept mode is enabled (see
Section 49.2 on page
MAC addresses listed for the port in the MAC filter settings.

49.3.1 MAC Count Show Command

Syntax:
ras> switch mac count show [portlist]
where
[portlist]
This command displays the MAC count settings on the specified ADSL port(s) or on all
ADSL ports if no port is specified.
The following example displays the MAC count settings for ADSL port 4.

Figure 178 MAC Count Show Command Example

ras> switch mac count show 4
port status count
---- ------ -----
4 V
324
The source MAC address in "00:a0:c5:12:34:56" format.
=
321), the IES-1248 ignores the MAC count setting and accepts all of the
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
128
Chapter 49 MAC Commands