Pae Pvc Set Command; Figure 294 Pae Pvc Set Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide

56.8.2 PAE PVC Set Command

Syntax:
ras> adsl paepvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority> [acname <acname>] [srvcname <srvcname>] [hellotime
<hellotime>]
where
<portlist>
<vpi>
<vci>
<DS vcprofile
[,US
vcprofile]>
<pvid>
<priority>
<acname>
<srvcname>
<hellotime>
This command creates a PPPoA-to-PPPoE PVC to allow communication between the ATM
(CPE) and Ethernet network (BRAS) segments. The PVC is mapped to a PPPoE session that
connects to the specified BRAS.
The following example creates a PPPoA-to-PPPoE PVC (
1, and the IEEE 802.1p priority is 0. This configuration is for the
access concentrator. The switch waits 10 seconds before terminating the PPPoE session.

Figure 294 PAE PVC Set Command Example

ras> adsl paepvc set 1 1 33 DEFVAL 1 0 acname vom srvcname video hellotime 10
418
The port number of the PAE PVC. You can specify a single
=
ADSL port <1>, all ADSL ports <*> or a list of ADSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
The VPI of the PAE PVC.
=
The VCI of the PAE PVC.
=
Assign a VC profile to use for this channel's downstream traffic
=
shaping.
Assign a VC profile to use for policing this channel's upstream
=
traffic. The IES-1248 does not perform upstream traffic policing
if you do not specify an upstream VC profile.
1 – 4094; the VLAN Identifier to add to Ethernet frames that the
=
system routes using this PVC.
Set the IEEE 802.1p priority (0~7) to add to the traffic that uses
=
this PVC.
This field is optional. Specify the hostname of a remote access
=
concentrator if there are two access concentrators (or BRAS) on
the network or that you want to allow PAE translation to the
specified access concentrator.
This field is optional. Specify the name of the service that uses
=
this PVC. This must be a service name that you configure on the
remote access concentrator.
0 - 600; specify the timeout, in seconds, for the PPPoE session.
=
Enter 0 if there is no timeout.
) for port . The VLAN ID is
1/33 1
service on the
video
Chapter 56 Virtual Channel Management
vom