Transparent Lan Service (Tls) Commands; Tls Pvc Delete Command - ZyXEL Communications IES-1248-51 User Manual

Each value is described below.
tx/rx
ppp lcp config-
request
ppp lcp echo-
request
ppp lcp echo-
reply
pppoe padi
pppoe pado
pppoe padr
pppoe pads
pppoe padt
pppoe srvcname
error
pppoe ac system
error
pppoe generic
error

56.9 Transparent LAN Service (TLS) Commands

Note: You can NOT configure PPPoA-to-PPPoE and TLS settings on the same PVC.

56.9.1 TLS PVC Delete Command

Syntax:
ras> adsl tlspvc delete <portlist> <vpi> <vci>
where
<portlist>
<vpi>
Chapter 56 Virtual Channel Management
The values in these columns are for packets transmitted (
=
received ( ) by the IES-1248.
rx
The number of config-request PDUs received by the IES-1248
=
from the CPE (client) device.
The number of echo-request PDUs received by the IES-1248
=
from the CPE (client) device.
The number of echo-reply PDUs received by the IES-1248 from
=
the CPE (client) device.
The number of padi PDUs sent by the IES-1248 to the BRAS.
=
The number of pado PDUs sent by the BRAS to the IES-1248.
=
The number of padr PDUs sent by the IES-1248 to the BRAS.
=
The number of pads PDUs sent by the BRAS to the IES-1248.
=
The number of padt PDUs sent and received by the IES-1248.
=
The number of service name errors; for example, the IES-1248's
=
specified service is different than the BRAS's setting.
The number of times the access concentrator experienced an
=
error while performing the Host request; for example, when
resources are exhausted in the access concentrator. This value
does not include the number of times the IES-1248 checks the
AC name field in the BRAS's reply PDU and finds a mismatch,
however.
The number of other types of errors that occur in the PPPoE
=
session between the IES-1248 and the BRAS.
The port number of the TLS PVC. You can specify a single
=
ADSL port <1>, all ADSL ports <*> or a list of ADSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
The VPI of the TLS PVC.
=
IES-1248-51/51A/53 User's Guide
) or
tx
421