Tls Pvc Set Command; Tls Pvc Show Command; Figure 298 Tls Pvc Set Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
<vci>
This command clears TLS settings for the PVC.

56.9.2 TLS PVC Set Command

Syntax:
ras> adsl tlspvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority>
where
<portlist>
<vpi>
<vci>
<DS vcprofile
[,US
vcprofile]>
<pvid>
<priority>
This command sets the second VLAN tag to add to the packets from the PVC.
The following example adds VLAN tag
( ) on port
1/33

Figure 298 TLS PVC Set Command Example

ras> adsl tlspvc set 2 1 33 DEFVAL 100 0

56.9.3 TLS PVC Show Command

Syntax:
ras> adsl tlspvc show <portlist> [<vpi> <vci>]
422
The VCI of the TLS PVC.
=
The port number of the TLS PVC. You can specify a single
=
ADSL port <1>, all ADSL ports <*> or a list of ADSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
The VPI of the TLS PVC.
=
The VCI of the TLS PVC.
=
Assign a VC profile to use for this channel's downstream traffic
=
shaping.
Assign a VC profile to use for policing this channel's upstream
=
traffic. The IES-1248 does not perform upstream traffic policing
if you do not specify an upstream VC profile.
1 – 4094; the (second) VLAN Identifier to add to Ethernet
=
frames that the system routes using this PVC.
Set the IEEE 802.1p priority (0~7) to add to the traffic that uses
=
this PVC.
.
2
to traffic using the
100 DEFVAL
Chapter 56 Virtual Channel Management
ATM profile on PVC