Chapter 49 Mac Commands; Mac Commands Overview; Mac Filter Commands; Mac Filter Show Command - ZyXEL Communications IES-1248-51 User Manual

This chapter describes how to configure the IES-1248's MAC commands.

49.1 MAC Commands Overview

Use the MAC commands to configure MAC filtering or limit the MAC count.

49.2 MAC Filter Commands

Use the MAC filter to control from which MAC (Media Access Control) addresses frames can
(or cannot) come in through a port.

49.2.1 MAC Filter Show Command

Syntax:
ras> switch mac filter show [portlist]
where
<portlist>
This command displays the MAC filtering status (V for enabled, - for disabled) and the fixed
source MAC addresses on the specified ADSL port(s) or on all ADSL ports if no port is
specified.
The following example displays the MAC filtering mode, status and the fixed source MAC
addresses on ADSL port 5.

Figure 172 MAC Filter Show Command Example

ras> sw mac filter show 5
status:V, enable mac filter function.
status:-, disable mac filter function.
port mode
---- ------ ------ -----------------
5 accept

Chapter 49 MAC Commands

You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
status mac
- 00:a0:c5:12:34:56
IES-1248-51/51A/53 User's Guide
C
H A P T E R
MAC Commands
4 9
321