Rpvc Arp Agingtime Set Command; Rpvc Arp Agingtime Show Command; Figure 290 Rpvc Route Delete Command Example; Figure 291 Rpvc Arp Agingtime Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
The following example removes a domain for a CPE device is connected to DSL port 1 on the
IES-1248 and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and VCI 35.
The CPE device's LAN IP address is 10.10.10.10 and uses a subnet mask of 255.255.255.0.
This includes the CPE device's LAN IP addresses and the IP addresses of the LAN computers.

Figure 290 RPVC Route Delete Command Example

ras> adsl rpvc route delete 1 8 35 10.10.10.1/24

56.7.11 RPVC ARP Agingtime Set Command

Syntax:
ras> adsl rpvc arp agingtime set <sec>
where
<sec>
This command configures how long the device stores the IP addresses of CPE devices using
2684 routed mode in the Address Resolution Protocol table.
The following example sets the device to store the IP addresses 2684 routed mode gateways in
the Address Resolution Protocol table for 500 seconds.

Figure 291 RPVC ARP Agingtime Command Example

ras> adsl rpvc arp agingtime set 500

56.7.12 RPVC ARP Agingtime Show Command

Syntax:
ras> adsl rpvc arp agingtime show
This command displays how long the device stores the IP addresses of 2684 routed mode
gateways in the Address Resolution Protocol table.
The following is an example.

Figure 292 RPVC ARP Agingtime Show Command Example

ras> adsl rpvc arp agingtime show
rpvc aging time (sec): 500
416
The number of seconds (10~10000) the device is to keep the
=
Address Resolution Protocol table's entries of IP addresses of
2684 routed mode gateways. Use 0 to disable the aging time.
Chapter 56 Virtual Channel Management