ZyXEL Communications IES-1248-51 User Manual page 150

IES-1248-51/51A/53 User's Guide
Table 28 IGMP Filter Profile (continued)
LABEL
End IP
Add
Cancel
150
DESCRIPTION
Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.
If you want to add a single multicast IP address, enter it in both the Start IP and
End IP fields.
Click Add to save your changes to the IES-1248's volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to start configuring the screen again.
Chapter 17 xDSL Profiles Setup