Using The Ftp Command From The Dos Prompt - ZyXEL Communications Prestige 202 User Manual

Step 4.
Launch TFTP client on your workstation and connect to the Prestige. Set the
transfer mode to binary before starting data transfer.
Step 5. Use the TFTP client to transfer files between the Prestige and the workstation.
The file name for the firmware is "ras" and for the configuration file, "rom-0"
(rom-zero, not capital o).
If you upload the firmware to the Prestige, it will reboot automatically when the file transfer is
completed.
NOTE: Telnet connection must be active and the SMT in CI mode before and
For details on TFTP commands (see following example), please consult the documentation of
your TFTP client program. For UNIX, use "get" to transfer from the Prestige to the workstation,
"put" the other way around, and "binary" to set binary transfer mode.
With serial (XMODEM) transfer, the filenames on the PC are your choice. With many ftp and tftp
clients, they are as well as seen next.
ftp> put P202.bin ras
This is a sample ftp session showing the transfer of the PC file "P202.bin" to the Prestige.
ftp> get rom-0 MyP202.cfg
This is a sample ftp session saving the current configuration to the PC file MyP202.cfg.

Using the FTP Command From the DOS Prompt

Step 1. Launch the FTP client on your workstation.
Type open and the IP address of your Prestige.
Step 2.
Step 3. You may press [Enter] when prompted for a username.
Step 4. Type root and your SMT password as requested. The default is 1234.
Type bin to set transfer mode to binary.
Step 5.
Step 6. Use put to transfer files from the workstation to the Prestige, e.g., put p202.bin
ras transfers the firmware on your computer (p202.bin) to the Prestige and renames it
"ras". Similarly put p202.rom rom transfers the configuration file on your
computer (p202.rom) to the Prestige and renames it "rom".
System Maintenance
during the TFTP transfer.
Prestige 202 ISDN Router
12-19