Adsl Profile Map Command; Figure 230 Adsl Profile Delete Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide

55.1.7 ADSL Profile Map Command

Syntax: (IES-1248-51/51A)
ras> adsl profile map <portlist> <profile>
-> <glite|gdmt|t1413|auto|adsl2|adsl2+>
Syntax: (IES-1248-53)
ras> adsl profile map <portlist> <profile>
-> <gdmt|etsi|auto|adsl2|adsl2+>
where
<portlist>
<profile>
<glite|gdmt|ets
i|t1413|auto|ad
sl2|adsl2+>
This command assigns a specific profile to an individual port and sets the port's ADSL mode
(or standard). The profile defines the maximum and minimum upstream/downstream rates, the
target upstream/downstream signal noise margins, and the maximum and minimum upstream/
downstream acceptable noise margins of all the ADSL ports to which you assign the profile.
When set to auto, the port follows whatever mode is set on the other end of the line.
Note: When the mode is set to
negotiated ADSL mode regardless of the rates configured in the profile. For
example, if the profile is set to use a rate of 18000 Kbps, that speed is only
supported if the negotiated ADSL mode is ADSL 2+. Any other ADSL mode will
limit the rate to what is supported by the specific ADSL standard.
When the mode is set to
been removed from the
a line in
in
t1413
to explicitly configure the line in
The following example sets ADSL port 1 to have the gold profile in G.dmt mode.

Figure 230 ADSL Profile Delete Command Example

ras> adsl profile map 1 gold gdmt
368
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
The profile that will define the settings of this port.
=
The ADSL operational mode. The IES-1248-51/51A and the
=
IES-1248-53 have different choices.
auto
auto
mode selection list. When a profile is assigned to
auto
mode, the line will not go to showtime if the modem is configured
auto
mode only or if it is an old modem that only supports
, the connection rates are governed by the
in the IES-1248-51/51A, the
mode to make the modem initialize.
t1413
mode has
t1413
. You have
t1413
Chapter 55 ADSL Commands