ZyXEL Communications IES-1248-51 User Manual page 102

IES-1248-51/51A/53 User's Guide
Table 11 System Info (continued)
LABEL
Status
External Alarm
Status
Name
Apply
External Relay
Status
New threshold
Apply
Index
Temperature (Hi)
Temperature (Lo)
Volt. (Hi)
Volt. (Lo)
Fan (Hi)
Fan (Low)
Poll Interval(s)
Set Interval
Stop
102
DESCRIPTION
Normal indicates that the RPM is within an acceptable operating range at this
point; otherwise Abnormal is displayed.
The IES-1248 is able to detect alarm input from other equipment connected to
the ALARM connector.
The Status column displays Normal when no alarm input has been detected
from other equipment. It displays Abnormal when alarm input has been
detected from other equipment.
Use the Name column to configure a title for each external alarm for
identification purposes. Use up to 31 characters.
Click Apply to save the name changes to the IES-1248's volatile memory. The
IES-1248 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
The IES-1248 is able to send alarm output to another piece of equipment
connected to the ALARM connector.
The Status column displays Normal when the IES-1248 is not sending alarm
output to another piece of equipment. It displays Abnormal when the IES-1248
is sending alarm output to another piece of equipment.
Use this section of the screen to configure the hardware monitor threshold
settings.
Configure new threshold settings in the fields below and click Apply to use
them.
This field is a sequential value.
Use these fields to configure the highest temperature limit at each sensor.
Use these fields to configure the lowest temperature limit at each sensor.
Use these fields to configure the highest voltage limit at each sensor.
Use these fields to configure the lowest voltage limit at each sensor.
Use these fields to configure the highest RPM limit at each sensor.
Use these fields to configure the lowest RPM limit at each sensor.
The text box displays how often (in seconds) this screen refreshes. You may
change the refresh interval by typing a new number in the text box and then
clicking Set Interval.
Click Stop to halt statistic polling.
Chapter 10 System Information