Ppvc Set Command; Ppvc Member Set Command; Figure 274 Ppvc Set Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide

56.4.1 PPVC Set Command

Syntax:
ras> adsl ppvc set <portlist> <vpi> <vci> <encap> <pvid> <priority>
where
<portlist>
<vpi>
<vci>
<encap>
<pvid>
<priority>
This command creates a PPVC.
The following example creates a PPVC with VPI 8 and VCI 35 for port 5. The PPVC uses llc
encapsulation and default VID 25. Any frames received without an IEEE 802.1p priority tag
will be assigned a priority of 3. The IES-1248 uses this PVC channel internally. This PVC is
not needed on the subscriber's device.

Figure 274 PPVC Set Command Example

ras> adsl ppvc set 5 8 35 llc 25 3

56.4.2 PPVC Member Set Command

Syntax:
ras> adsl ppvc member set <portlist> <vpi> <vci> <member vpi> <member vci>
<DS vcprofile[,US vcprofile]> <level>
404
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
The VPI setting can be 0 to 255.
=
The VCI setting can be 32 to 65535 if the vpi is 0 or 1 to 65535
=
if the vpi is not 0. This PVC channel is for internal use. The
operator does not need to create this PVC on the subscriber's
device (the CPE).
The type of encapsulation: llc, vcmux
=
Type a PVID (Port VLAN ID) to assign to untagged frames
=
received on this PPVC.
This is the priority value (0 to 7) to add to incoming frames
=
without a (IEEE 802.1p) priority tag.
Chapter 56 Virtual Channel Management