The vendor ID, vendor version number and product serial number are obtained from vendor
ID fields (see ITU-T G.994.1) or R-MSGS1 (see T1.413).
55.2.4 Lineperf Command
Syntax:
ras> statistics adsl lineperf <portlist>
where
<portlist>
This command shows the line performance counters of an ADSL port.
An example is shown next.
Figure 255 Lineperf Command Example
ras> statistics adsl lineperf 1
[port 1] Perf since boot up
nfebe-I/nfebe-ni
ncrc-I/ncrc-ni
nfecc-I/nfecc-ni
nfec-I/nfec-ni
init-atuc/init-atur:
es-atuc /es-atur
ses-atuc /ses-atur :
uas-atuc /uas-atur :
lpr-atuc /lpr-atur :
These counters display line performance data that has been accumulated since the system
started. In the list above the definitions of near end/far end will always be relative to the ATU-
C (ADSL Termination Unit-Central Office). Downstream (ds) refers to data from the ATU-C
and upstream (us) refers to data from the ATU-R. "I" stands for interleaved and "ni" stands for
non-interleaved (fast mode).
A block is a set of consecutive bits associated with the path; each bit belongs to one and only
one block. Consecutive bits may not be contiguous in time.
Table 98 Line Performance Counters
LABEL
nfebe
ncrc
nfecc
Chapter 55 ADSL Commands
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
:
46/
:
5/
:
0/
:
28/
23/
:
27/
26/
1515/
-/
DESCRIPTION
The Number of Far End Block Errors (Cyclic Redundancy Check).
Near end Cyclic Redundancy Check errors.
The Far End blocks repaired by Forward Error Correction.
IES-1248-51/51A/53 User's Guide
0 (Far End CRC)
0 (Near End CRC)
0 (Far End Corrected FEC)
0 (Near End Corrected FEC)
-
92
60
1515
2
383