Rpvc Show Command; Figure 285 Rpvc Set Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
DS vcprofile
[,US
vcprofile]>
<ip>
/<netmask>
<gateway ip>
This command adds a PVC to handle 2684 routed mode traffic.
Note: You must use the
settings before you use the
The following example adds a PVC for 2684 routed mode traffic. It is for DSL port 1, VPI 8,
VCI 35. It sets the DEFVAL profile for downstream traffic shaping and for upstream traffic
policing. The CPE device's WAN IP address is 192.168.10.200 with a netmask of 32 and the
gateway's IP address is 192.168.10.102.

Figure 285 RPVC Set Command Example

ras> adsl rpvc set 1 8 35 DEFVAL,DEFVAL 192.168.10.200/32 192.168.10.102

56.7.6 RPVC Show Command

Syntax:
ras> adsl rpvc show <portlist>
412
Assign a VC profile to use for this channel's downstream traffic
=
shaping.
Assign a VC profile to use for policing this channel's upstream
=
traffic. The IES-1248 does not perform upstream traffic policing
if you do not specify an upstream VC profile.
The subscriber's CPE WAN IP address in dotted decimal
=
notation.
The bit number of the subnet mask of the subscriber's IP
=
address. To find the bit number, convert the subnet mask to
binary and add all of the 1's together. Take "255.255.255.0" for
example. 255 converts to eight 1's in binary. There are three
255's, so add three eights together and you get the bit number
(24).
Make sure that the routed PVC's subnet does not include the
IES-1248's IP address.
The IP address of the gateway to which you want to send the
=
traffic that the system receives from this PVC. Enter the IP
address in dotted decimal notation.
rpvc gateway set
rpvc set
command to configure the gateway's
command.
Chapter 56 Virtual Channel Management