Rpvc Gateway Set Command; Rpvc Gateway Show Command; Figure 281 2684 Routed Mode Commands Example; Figure 282 Rpvc Gateway Set Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
• In general deployment, the computer must set the CPE device's LAN IP address
(10.10.10.10 in this example) as its default gateway.
• The subnet range of any RPVC and RPVC domain must be unique.
Use the following command sequence to configure the IES-1248 for this example set up.

Figure 281 2684 Routed Mode Commands Example

ras> adsl rpvc gateway set 192.168.10.102 1
ras> adsl rpvc set 1 8 35 DEFVAL 192.168.10.200/32 192.168.10.102
ras> adsl rpvc route set 1 8 35 10.10.10.1/24

56.7.2 RPVC Gateway Set Command

Syntax:
ras> adsl rpvc gateway set <gateway ip> <vlan id> [<priority>]
where
<gateway ip>
<vlan id>
[<priority>]
This command adds a gateway IP address to use for 2684 routed mode traffic.
The following example has the device use a VLAN ID of 1 and IEEE 802.1p priority of 3
when sending 2684 routed mode traffic to a gateway at IP address 192.168.10.102.

Figure 282 RPVC Gateway Set Command Example

ras> adsl rpvc gateway set 192.168.10.102 1 3

56.7.3 RPVC Gateway Show Command

Syntax:
ras> adsl rpvc gateway show
This command displays
routed mode traffic.
410
The IP address of the gateway to which you want to send the
=
traffic that the system receives from this PVC. Enter the IP
address in dotted decimal notation.
The VLAN Identifier to add to Ethernet frames that the system
=
routes to this gateway.
Set the IEEE 802.1p priority (0~7) to add to the traffic that you
=
send to this gateway.
the gateway IP addresses that are configured for use with 2684
Chapter 56 Virtual Channel Management