Data Backup And Series Commissioning - Siemens SINAMICS G120 Operating Instructions Manual

Data backup and series commissioning

External data backup
After commissioning, your settings are saved in the converter so that they are protected
against power failure.
We recommend that you additionally back up the parameter settings on a storage medium
outside the converter. Without backup, your settings could be lost if the converter developed
a defect (see also Steps for replacing the inverter (Page 269)).
The following storage media are available for your settings:
1. Memory card
2. PC/PG
3. Operator Panel
Series commissioning
Series commissioning is the commissioning of several identical drives. After commissioning
of the first drive, you must do the following:
1. Back up the settings of the first converter to an external storage medium.
2. Transfer the settings of the first converter to another converter via the storage medium.
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
Note
The control unit to which the parameters are transferred must have the same order
number and the same or a higher firmware version as the source control unit.
10
247