Siemens SINAMICS G120 Operating Instructions Manual page 326

Appendix
A.3 Application examples
Then save your hardware configuration with "Save and compile" (
completed configuring the device in STEP 7.
Note
STEP 7 with Drive ES Basic
If you have installed Drive ES Basic, you can now integrate the converter via the object
manager and open STARTER in HW Config by double-clicking the converter. In this case,
STARTER automatically accepts the device name and IP address. As a consequence, the
procedure described in Section Connect the converter to PROFINET (Page 87) is
superfluous.
In the next step, load the configuration into the control by clicking the
screen form, set the IP address of the control.
If you do not have the IP address readily available, you can display the participants that can
be reached by clicking the "Display" button. Select the control from the list of accessible
participants (
The CPU must be stopped to complete the loading process.
If you have installed Drive ES Basic, open STARTER by double-clicking the converter
symbol in the Hardware Manager and configure the converter in STARTER.
If you are working with the GSDML, now close HW Config and insert the converter in the
SIMATIC Manager as described in the following section.
324
⑥
), and exit the screen form with OK.
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
). You have now
button. In the next