Siemens SINAMICS G120 Operating Instructions Manual page 67

● Start the STARTER commissioning software.
● If you are using STARTER for the first time, you must check whether the USB interface is
Case 1: USB interface OK - no setting is required
If the interface is correctly set, the following screen form shows the converter, which is
directly connected to your computer via the USB interface.
● Close this screen form, without selecting the converter(s) that has/have been found.
● Create your STARTER project.
Case 2: USB interface must be set
In this case, the message box "no other nodes found" is displayed.
● Set the following in the "Accessible participants" screen form:
● Close this screen form, without selecting the converter(s) that has/have been found.
● Create your STARTER project.
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
correctly set. To do this, click in STARTER on
①
– Under "Access point activate "DEVICE (STARTER, Scout)"
②
– Under " PG/PC" select "S7USB"
③
– Then click on "Update"
Basic commissioning
6.5 Basic commissioning with STARTER
("Accessible participants").
65