Siemens SINAMICS G120 Operating Instructions Manual page 268

Data backup and series commissioning
10.5 Write and know how protection
2. The machine manufacturer goes online on the sample machine.
3. The end customer inserts the memory card and switches on the converter.
When powering up, the converter checks the serial numbers of the card and when there is a
match, the converter goes into the "ready to start" state.
If the numbers do not match, then the converter signals fault F13100 (no valid memory card).
Case 2: The machine manufacturer knows the serial number of the new converter and the
serial number of the MMC
Procedure
1. The end customer provides the machine manufacturer with the following information:
2. The machine manufacturer goes online on the sample machine.
3. The end customer copies the project to the Siemens memory card that belongs to the
When powering up, the converter checks the serial numbers of the card and when there is a
match, the converter goes into the "ready to start" state.
If the numbers do not match, then the converter signals fault F13100 (no valid memory card).
266
– deactivates the know-how protection, see Settings for the know-how protection
(Page 263)
– enters the serial number of the new converter in p7759
– enters the serial number of the inserted memory card as reference serial number in
p7769
– activates the know-how protection with copy protection ("Copy RAM to ROM" must be
activated!), see Settings for the know-how protection (Page 263)
– writes the configuration with p0971 = 1 to the memory card
– sends the memory card to the end customer
– For which machine must the converter be replaced?
– What is the serial number (r7758) of the new converter?
– What is the serial number of the memory card?
– deactivates the know-how protection, see Settings for the know-how protection
(Page 263)
– enters the serial number of the new converter in p7759
– enters the serial number of the customer's memory card as reference serial number in
p7769
– activates the know-how protection with copy protection ("Copy RAM to ROM" must be
activated!), see Settings for the know-how protection (Page 263)
– writes the configuration with p0971 = 1 to the memory card
– copies the encrypted project from the card to his PC
– for example, sends it by e-mail to the end customer
machine, inserts it in the converter and switches on the converter.
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB