Transferring The Setting From The Memory Card - Siemens SINAMICS G120 Operating Instructions Manual

10.1.2

Transferring the setting from the memory card

Procedure
 The converter power supply has been switched off.
 If there is valid parameter data on the memory card, then the converter accepts the data
Procedure: Manual data transfer from a memory card
 The converter power supply has been switched on.
 Insert a memory card into the converter.
Procedure with the BOP-2
 Start data transfer in the menu "EXTRAS" - "FROM CRD".
 Switch off the converter power supply.
 Wait until all LED on the converter go dark. Now switch on the
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
1. Insert the memory card into the
converter.
from the memory card.
converter power supply again. Your settings only become effective
after this power-on reset.
Data backup and series commissioning
10.1 Backing up and transferring settings using memory card
2. Then switch-on the converter power
supply.
OK
OK
251