Checking Ipv6 Configurations On The Cli; Verification Of Detection Resources On The Cli; Viewing The Enabled Rules On The Cli; Threat Protection System Troubleshooting Guide - Nortel 2070 Troubleshooting Manual

Checking IPv6 configurations on the CLI

This section describes checking IPv6 configurations on the command line
interface (CLI).
Procedure 29
Procedure steps
Step
1
2

Verification of Detection Resources on the CLI

This section describes the verification of the maximum and optimal number
of detection resources in CLI.
Procedure 30
Procedure steps

Viewing the enabled rules on the CLI

This section describes viewing enabled rules on the CLI.
Procedure 31
Procedure steps
Step
1
Copyright © 2007 Nortel Networks
.
Action
Enter the following command on the CLI
/var/sf/detection_engines/[uuid]/
Disable SMTP globally in Detection and Prevention options
for a particular policy, when working on the IPv6 partial support
feature.
Action
Enter the following command in the CLI.
/etc/sf/ims.conf – Search for MAX_NUM_DR/OPTIMAL
_NUM_DR
Action
Enter the following command in the CLI.
/var/sf/detection_engines/[de uuid]/active.rules.
Nortel TPS 4.7

Threat Protection System Troubleshooting Guide

NN47240-700
11 2007
Viewing the enabled rules on the CLI 41
--End--
01.01 Standard