Pinion Gear And Driveshaft Removal - "S2" Type - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

GEARCASE – STANDARD ROTATION
GEARCASE DISASSEMBLY
Pull propeller shaft and bearing housing far
enough to loosen the PRESSED bearing housing
from the gearcase housing.
"L2" Type Gearcase
"M2" Type Gearcase
Remove the bearing housing, thrust washer,
thrust bearing, and reverse gear from gearcase.
278
Pinion Gear and Driveshaft
Removal – "S2" Type
IMPORTANT:
from the lower driveshaft, the upper retainer must
be removed and upper driveshaft must slide down
into lower driveshaft.
Remove the four driveshaft bearing housing
screws and bearing housing.
006836
1
1. Driveshaft bearing housing screws
Remove upper retainer.
006837
1
1. Retainer
006838
To separate the upper driveshaft
1
005422
005423