Installation - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

Thread Slide Hammer, P/N 432128, into the

adapter until at least 2 in. (51 mm) of thread are

Pull tilt tube from stern bracket with the slide ham-

mer. When tilt tube clears the port stern bracket,

remove tilt tube from the spacer.

Installation

Thread starboard end of tilt tube into the spacer.

Thread the adapter onto port end of tilt tube.

Use a wood or leather mallet to tap the tilt tube

into position.

Make sure the lock tab is in correct position.

Install the starboard locknut.

Replace locknut if definite resistance is

Tighten starboard tilt tube nut to a torque of 45 to

50 ft. lbs. (61 to 68 N·m).

Replace steering cable wiper nut on port end of tilt

Apply one drop of instant bonding adhesive in

receiving channels of tilt limit switch collar and

install collar and tilt cam on tilt tube. Be sure locat-

ing tab on collar fits in hole on tilt tube.

Table of Contents