BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 46

ROUTINE SERVICE
STORAGE
I-Command Method
I-Command 3.5 inch digital gauges (with software
version 1.4.0 or higher) provide a winterize feature
for 2008 and newer V4 and V6 models.
1
I-Command 3.5 inch Digital Gauge
1. Menu button
Start the engine:
•
Press the MENU button. Use the UP or DOWN
buttons and select SYSTEM SETUP. Press the
ENTER button.
•
Use the UP or DOWN buttons and select BUS
DEVICES. Press the ENTER button. The gauge
will search for devices.
•
Use the UP or DOWN buttons and select
engine to winterize. Press the ENTER button.
•
The gauge will display WINTERIZE menu.
Press the ENTER button. Press ENTER button
again.
•
The gauge will display WINTERIZATION mes-
sage.
•
When prompted, engage NEUTRAL only button
on throttle and advance THROTTLE ONLY to at
least 50%.
•
Gauge will display
PROGRESS message. Outboard will automati-
cally go to fast idle and fog itself. Allow outboard
to run until it shuts itself off (about one minute)
•
Gauge will display WINTERIZATION IS COM-
PLETE message.
•
Press EXIT to return to BUS DEVICES menu.
Repeat steps 3 through 8 for other engines
(multi-engines set up only).
44
008191
WINTERIZATION IN
Additional Recommendations
•
Top off oil reservoir.
•
inspect the fuel filter. If there is debris in the fuel
filter, it must be replaced.
•
Replace gearcase lubricant.
•
Remove and inspect propeller.
•
Clean and grease propeller shaft.
•
Blow water from gearcase speedometer pickup
system (gearcase speedometer models only).
•
Lubricate all grease fittings and linkages.
•
Inspect outboard, steering system, and con-
trols. Replace all damaged and worn compo-
nents. Refer to manufacturer's and lubrication
recommendations.
•
Touch up painted surfaces as needed. Coat
outer painted surfaces with automotive wax.
•
Remove battery(s) from boat. Store in a cool,
dry location. Periodically charge battery(s) while
stored. Refer to manufacturer's maintenance
recommendations when servicing batteries.
•
Store outboard in upright (vertical) position.
•
Check for fuel leakage.
WARNING
Failure to check for fuel leakage could
allow a leak to go undetected, resulting in
fire or explosion.