BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 314

GEARCASE – COUNTER ROTATION
SHIFTER, BEARING AND SEAL SERVICING
Install arms of shift lever into detent slots. Align
the pivot holes and insert the retaining pin. Push
shifter detent down.
1. Pin, shift lever
Inspect clutch shaft detent balls, retainer and
spring. These parts should not require removal
under normal servicing.
WARNING
Wear safety glasses to avoid injury.
If these parts are damaged or removed, a new
service kit should be installed. Refer to parts cata-
log for kit part number.
1
2
1. Clutch Shaft Retainer Kit
2. Clutch Shaft
312
Coat thrust bearing and thrust washer with Needle
Bearing grease. Place the bearing on the back of
the gear. Set the washer on top of the thrust bear-
ing. Insert the gear, bearing, and washer into the
bearing housing.
1
NOTICE
Bearing
installed in the correct order.
2
006861
1. Thrust bearing
2. Thrust washer
Align holes in the clutch dog with slot in the pro-
peller shaft. Install the clutch dog on the shaft with
"PROP END" facing rear of the shaft.
NOTICE
The clutch dog is not symmetrical.
If installed backward, it will not fully engage
and will immediately damage itself and the
gears.
0000
1. "PROP END"
and washer must
DSC02297
006906
be
1
1