Ignition Timing; Tps Calibration; Fuel Injector Servicing - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS

Ignition Timing

Use the Ignition Timing screen to check and
adjust EMM timing. EMM timing must be synchro-
nized to crankshaft position.
Refer to TIMING ADJUSTMENTS on p. 114.
Check timing after any of the following proce-
dures:
•
Powerhead replacement
•
Crankshaft replacement
•
Flywheel removal or replacement
•
CPS replacement
•
EMM replacement
•
EMM software replacement
IMPORTANT:
Make sure the timing pointer is
set and the outboard reaches operating tempera-
ture before making adjustments.
66

TPS Calibration

TPS Calibration synchronizes throttle plate open-
ing with throttle position sensor voltage.
Refer to TPS Calibration on p. 116.
1
1. TPS Calibration button
Perform TPS Calibration after replacing or adjust-
008110
ing any throttle body or throttle linkage parts.

Fuel Injector Servicing

All E-TEC fuel injectors use software program-
ming to compensate for variations in fuel flow.
Each injector and its location on the outboard is
identified by the EMM. DO NOT install an injector
without updating the compensation software.
To install a service injector, click the "Replace"
button on the Injector Coefficients screen and
select the file for the replacement injector. Refer to
Fuel Injector Service on p. 150.
008108
008101