BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 204

Table of Contents

POWERHEAD DISASSEMBLY

Remove upper seal from crankshaft. Discard the

seal. A new upper seal must be installed on

Remove the lower bearing seal housing.

Remove the housing O-ring. Discard O-ring.

Use a punch to remove the housing seal. Discard

Inspect housing and replace if necessary.

Remove the O-ring from crankshaft sleeve and

inspect it. Replace the O-ring if it is not in good

Inspect the crankshaft sleeve and replace if nec-

essary. To remove the sleeve, use Slide Hammer,

P/N 432128, and Large Puller Jaws, P/N 432129.

Chapters

Table of Contents