BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 291

Place the shift lever arms into the recesses of the
shift cradle. Pull shifter detent back up to NEU-
TRAL position to hold the cradle and shaft in
place.
Coat thrust bearing and thrust washer with Needle
Bearing grease. Place the bearing on the back of
the gear. Set the washer on top of the thrust bear-
ing. Insert the gear, bearing, and washer into the
bearing housing.
NOTICE
Bearing and
installed in the correct order.
2
1. Thrust bearing
2. Thrust washer
001219
washer must be
1
DSC02297
GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICE
Align holes in the clutch dog with slot in the pro-
peller shaft. Install the clutch dog on the shaft with
"PROP END" facing rear of the shaft.
NOTICE
The clutch dog is not symmetrical.
If installed backward, it will not fully engage
and will immediately damage itself and the
gears.
1. "PROP END"
Slide the propeller shaft onto the shift shaft, align
the hole in the shaft with the hole in the clutch
dog, install the pin and then, a new clutch dog
retaining spring. Place three coils over each end
of the pin, MAKING SURE NONE OF THE COILS
OVERLAP OR ARE LOOSE.
1. Retaining spring
1
006906
1
006907
12
289