BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 249

Check that exhaust valve linkage is oriented as
shown.
Apply a small amount of Triple-Guard grease to
the actuator shaft and o-ring.
1
1. Shaft
2. O-ring
Carefully engage actuator shaft in linkage lever.
Rotate and push actuator into position. Apply Tri-
ple-Guard grease to screw threads.
Install screws and washers. Tighten screws to 60
to 84 in. lbs. (7 to 9.5 N·m).
1
007184
1. Actuator screws
Apply Adhesive 847 to the bottom flange of the
exhaust housing. Install a new seal. Apply Triple-
Guard grease to outer seal surface.
2
1
005209
1. Adhesive 847
2. Triple-Guard grease
007183
MIDSECTION
EXHAUST HOUSING SERVICE
1
007182
2
007181
11
247