GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
Install housing into gearcase. Align screw holes
with retainer slots in gearcase.
Use Installer Handle, P/N 345822, Propeller Shaft
Bearing Housing Installer, P/N 354058, Gearcase
Fixture, P/N 354059 and an appropriate floor
press (10 ton or greater) to install housing into
gearcase. Align and level gearcase assembly in
fixture as shown. Secure fixture to floor press.
304
Housing must be completely seated in gearcase
to install retainer tabs. Depth to retainer tab sur-
face
on
bearing
1 in. (25.4 mm).
006836
Install two retainers, washers and screws. Apply
Ultra Lock to threads and tighten screws to a
torque of 18 to 20 ft. lbs. (24 to 27 N·m).
1. Retainer tab screws
006844
housing
is
approximately
006845
1
001989