BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 114

ELECTRICAL AND IGNITION
FLYWHEEL AND STATOR SERVICING
Use Flywheel Puller Adaptor Kit, P/N 5007181,
and Flywheel Service Kit, P/N 434649, to position
flywheel on top of crankshaft. Align the alignment
hole in flywheel with alignment pin of crankshaft.
Turn center screw counterclockwise to lower fly-
wheel onto crankshaft. Remove tools from the fly-
wheel and crankshaft.
CAUTION
To avoid damage to flywheel magnets, or
injury to fingers, Flywheel service kits,
P/N 434649 and P/N 5007181, must be
used to remove or install the flywheel.
Apply Triple-Guard grease to studs and install five
new flywheel retaining nuts and washers. Follow
torque sequence below. Tighten nuts to a torque
of 30 to 32 ft. lbs. (40.5 to 43 N·m).
3
5
Flywheel Torque Sequence
112
005383
1,6
4
2,7
DRC3737
Install the electrical harness base and secure with
four screws. Tighten screws to a torque of 60 to
84 in. lbs (7 to 9.5 N·m).
1
1. Harness base screws
Reconnect the stator connector, two port side trim
system connectors, port engine temperature sen-
sor, and the port ground terminal.
Reconnect the crankshaft position sensor, throttle
position sensor, air temperature sensor, and oil
pump electrical connectors.
Install the EMM. Refer to EMM SERVICING on
p. 68.
1
005378