BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 345

Separate the trim/tilt unit wires in the braided tube
to permit removal through the hole in the stern
bracket.
Remove the ground wire from the trim/tilt unit.
1. Ground wire
Remove the external snap rings from the upper
pin.
TRIM AND TILT REPLACEMENT
Use a punch to remove the upper pin.
Retract the tilt cylinder rod.
25078
Remove the external snap rings from the lower
pin.
1
25057
Use a punch to remove the lower pin and remove
the trim/tilt unit from the stern brackets.
25064
TRIM AND TILT
25065
25077
25076
13
343