BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 294

GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICE
Bearing Installation
Oil, then install new bearings in bearing housing.
Place the lettered end of the bearing case on the
bearing installer, then press the bearing into the
housing until the tool seats. When installed, the
lettered end of the bearing should be visible.
S R
TANDARD OTATION
Bearing Installation Tool:
•
P/N 326562 – front bearing "S2" type
•
P/N 339750 – front bearing "O" type
•
P/N 354139 – front bearing "L2" and "M2" type
•
P/N 326562 – rear bearing "S2" type
•
P/N 340820 – rear bearing "O" type
•
P/N 354139 – rear bearing "L2" and "M2" type
1
Front Bearing
1. Bearing installation tool
Rear Bearing
1. Bearing installation tool
292
H
OUSING
006909
006910
C R
OUNTER OTATION HOUSING
Bearing Installation Tool:
•
P/N 432401 – front bearing "O" and "M2" type
•
P/N 339750 – rear bearing "O" type
•
P/N 354139 – rear bearing, "M2" type
1
Front Bearing
1. Bearing installation tool
Rear Bearing
1. Bearing installation tool
1
006945
1
006910