GEARCASE
WATER PUMP SERVICE
On V6 models, install the water tube grommet with
the inside taper facing up.
1. Water tube grommet
On V6 models, apply Triple-Guard grease to
screw threads and install the impeller housing
cover. Tighten screws to a torque of 24 to 36 in.
lbs. (3 to 4 N·m).
On all models, apply Adhesive 847 to flat side of
the impeller housing grommet. Install the grom-
met, flat side down. Apply Triple-Guard grease to
the outer surface of the water tube grommet on V4
models.
V6 models
1. Impeller housing cover
2. Impeller housing grommet
272
2
1
V4models
1. Impeller housing grommet
2. Triple-Guard grease
32000
Lightly coat the inside of the liner with Triple-
Guard grease. With a counterclockwise rotation,
install the impeller into the liner with the slot for the
impeller key facing out.
Apply a thin bead of Adhesive 847 in the seal
groove, and install the special shaped O-ring seal.
1
2
1. O-ring
Apply Gasket Sealing Compound to both sides of
a new impeller plate gasket. Install the gasket and
32001
impeller plate.
1
32001
1
34815