Cylinder Head Installation - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Cylinder Head Installation

Install a new thermostat seal in cylinder head with
side marked "TO CYL HEAD" facing toward ther-
mostat.
Refer to THERMOSTAT SERVICING on p. 191
before installing cylinder head.
Lightly lubricate new cylinder head O-rings with
Triple-Guard grease and install in cylinder head.
1. O-Ring
Apply soapy water to water dam and insert into
block.
1
1. Water dam
Apply a 1/16 in. (2 mm) bead of RTV adhesive
around each water passage on the block and cyl-
inder head as shown.
1
1
1. RTV adhesive (24 locations)
2. Thermostat seat area
Install cylinder head with the thermostat toward
the top. Apply outboard lubricant to screw threads
005286
and install the cylinder head screws. DO NOT use
any sealant on threads
Following sequence stamped on cylinder head,
tighten all screws in stages to a torque of 168 to
192 in. lbs. (19 to 21.5 N·m).
1
005287
1. Cylinder head screws
POWERHEAD
POWERHEAD ASSEMBLY
2
1
005288
1
10
005289
211