Fuel Filter Service - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Wrap a shop towel completely around the pres-
sure test valve while connecting fitting from Fuel
Pressure Gauge, P/N 5007100, to top test fitting
of fuel pump/vapor separator assembly.
1. High pressure test fitting
Insert venting hose of gauge into a suitable con-
tainer.
Slowly open gauge's venting valve.
Clean up any spilled fuel.
1
1. Test fitting
2. Venting hose
3. Venting valve
FUEL COMPONENT SERVICING

Fuel Filter Service

Removal
Disconnect the battery cables at the battery.
Use an appropriate filter wrench to turn the filter in
a counterclockwise direction. Remove filter care-
1 fully to prevent spilling contents.
Inspect contents for any presence of water. If
water is present, identify the source and correct
the problem. Take additional fuel samples and
drain fuel tank(s), if necessary.
005334
1. Water-separating fuel filter
Installation
Lubricate filter seal with outboard lubricant and
3
position filter on threaded mounting tube of filter
bracket. Take care not to damage water in fuel
sensor probe. Turn filter clockwise onto the tube
until seated against the bracket.
2
Tighten filter approximately 3/4 turn after the gas-
ket contacts the bracket.
005335
Squeeze primer bulb to prime fuel system. Hold
pressure on bulb and check for fuel leaks.
Connect battery cables.
Run outboard and check for fuel leaks.
FUEL SYSTEM
1
7
005237
147