BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 223

Place the shift rod in the shift rod lever. Install the
retaining pin and washer. Tighten pin to a torque
of 60 to 84 in. lbs. (7 to 9.5 N·m).
1. Shift rod screw
IMPORTANT:
Make sure the gearcase shifts
solidly into both forward and reverse and that pro-
peller shaft spins freely in neutral.
Fill exhaust valve actuator electrical connector
with Electrical Grease and install on actuator (V4
models).
IMPORTANT:
Leave enough slack in harness
so that lower cover will not pull it away from actua-
tor.
1
1. Actuator connector
Connect the power trim connectors.
1
1
1. Tilt limit switch connector
2. Sending unit connector
005253
1. Tilt relay connector
Install air silencer and air temperature sensor.
005247
POWERHEAD
POWERHEAD INSTALLATION
2
005254
1
005255
10
005272
221