BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 154

FUEL SYSTEM
FUEL COMPONENT SERVICING
Use the drop down menu to navigate to the saved
coefficient file location.
The coefficient file name must match the serial
number of the injector.
Select the correct file for the injector.
Select the Replace Injector button.
1
2
3
1. Navigation menu
2. Injector coefficient file
3. "Replace Injector" button
After the upload is complete, the program will
return to the Cylinder tab.
Make sure the serial number displayed on the
screen matches the serial number printed on the
serial number label of the replacement injector.
1
1. Serial number
152
Install Injector
The following items and their mating surfaces
must be cleaned before reassembly:
•
Injector
•
Cylinder head
•
Adapter
•
Screws
•
Threaded areas
CAUTION
All injector components must be clean to
ensure correct torque tightening specifi-
cations. To prevent fuel leakage, carefully
follow these installation instructions.
Place injector and insulator in the proper cylinder
location.
IMPORTANT:
008335
or hoses during assembly.
Lubricate mounting screw threads and under the
head of the screw with a light coat of Triple-Guard
grease. Install washers (one per screw) on injec-
tor retaining screws. Install screws and washers
through ignition coil brackets, injector cup, and
insulator. Thread into cylinder head.
008118
Be careful not to pinch any wiring
002316