BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 129

Table of Contents

Terminal Removal

A tab on the back side of the terminal engages a

shoulder in the connector housing to hold the ter-

minal in place. The terminal is removed by releas-

ing the tab and then pushing the terminal and wire

through connector housing.

Insert a thin tool into the connector above the ter-

minal to release tab.

Terminal Installation

Install wire gasket on wires and feed wires

through the correct terminal position of the con-

nector housing. Terminal is crimped onto wire and

then pulled back into connector housing until lock-

ing tab engages and terminal is seated.

Crimping Terminals

Strip insulation back 3/16 in. (5 mm). Position end

of wire strands in terminal past the wire crimp area

and the end of insulation in the insulation crimp

area of the terminal.

Capture all wire strands in crimp; leave no loose

strands. Crimp wire and insulation securely using

crimping pliers.

ELECTRICAL AND IGNITION

CONNECTOR SERVICING

Chapters

Table of Contents