Oil Injection Pump Function Test; Oil Injection Fittings Flow Test; Low Oil Sending Unit Test - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

OILING SYSTEM
OILING SYSTEM TESTS

Oil Injection Pump Function Test

Remove oil distribution hose from fitting at crank-
case. Squeeze oil supply primer bulb to provide oil
to injection pump.
1. Crankcase fitting
Running Test
Start the outboard and observe oil flow. Confirm
that a small amount of oil is discharged while
injection pump is activated.
Static Test
Use the Evinrude Diagnostics software oil injector
test to activate injector. Confirm that a small
amount of oil is discharged while injection pump is
activated.
1
Static Tests Screen
1. Oil injector test button
178
Results:
•
Oil flows from hose, compare to oil flow at other
distribution hoses
•
If one or more hoses fail to discharge oil, check
for a kinked or restricted hose before replacing
the oil injection pump assembly.

Oil Injection Fittings Flow Test

Make sure the oil injection fittings of the cylinder
1
and crankcase assembly allow fluid to move.
Remove oil distribution hose from crankcase fit-
ting. Temporarily install a length of oil hose.on the
fitting.
Use a Syringe, P/N 346936, filled with isopropyl
alcohol to force fluid through hose and fitting.
005348

LOW OIL Sending Unit Test

Remove oil from the oil tank
Turn the key switch ON. The dash mounted
Engine Monitor system should show a LOW OIL
warning.
Once the warning has been confirmed, refill the oil
tank. The LOW OIL warning should stop when the
oil level exceeds one-quarter of oil tank's capacity.
008116